Pre-GO 8T
GNSS Receiver Board
The Pre-GO 8T features a u-blox NEO-M8 concurrent GNSS timing module and ST LIS3MDL compass, and an SMA connector for an external antenna (not included).
The u-blox NEO-M8 module recognizes multiple constellations simultaneously and uses GPS, Galileo and either GLONASS or BeiDou.

Pre-GO 8T 

Pre-GO 8T: GNSS Module
The Pre-GO 8T features a u-blox NEO-M8T single-frequency, concurrent GNSS timing module and ST LIS3MDL compass, and an SMA connector for an external antenna (not included).
The u-blox NEO-M8T module recognizes multiple constellations simultaneously and uses GPS, Galileo and either GLONASS or BeiDou, providing accuracy of ±2.0 m.
Connectors
This model includes an SMA connector for an external antenna (not included).
Connect to the NEO-M8T via a USB micro-B connection to get up and running quickly, or use the Dronecode 6-pin GNSS port for GNSS data via UART and compass data via I2C.
Included Components | ||
GPS receiver and SMA connector | A UBlox based GPS receiver with SMA connector for use with external active antennas. Includes mating connector for AeroCore. |
---|
GPS | Compatible with the GPS navigation system. |
---|---|
Magnetometer | Three-axis magnetic sensor. |
USB Device | Micro B USB Plug |
BeiDou | Compatible with the BeiDou navigation system. |
Dronecode | Compatible with the Dronecode standard. |
Galileo | Compatible with the Galileo navigation system. |
GLONASS | Compatible with the GLONASS navigation system. |
Key Components | ||
Micro B USB Plug | Micro B USB Plug |
|
---|---|---|
UBlox Neo-7P GPS Receiver Module | UBlox Neo-7P GNSS Receiver with PPP and raw data output |
Specs |
Mating Connectors |
Please read the instructions in the README file carefully before starting. Instructions and functions are explained in the file.
Files that are needed (such as bootloader and operating system) to create a bootable disk image, are available below.
Our Support page links additional resources.
Software Version: