Gumstix Pi HAT Sensor board

Gumstix Pi HAT Sensor board 
The Pi HAT Sensor Board provides 9-axis motion detection, Pre-GO connectability, and ambient pressure and temperature sensors along with an LED array and pushbuttons. It also includes an RTC.
Customize the Gumstix Pi HAT Sensor Board to your project’s specific needs in Geppetto.
What’s included: 1 × Pi HAT Sensor Board Key component 1 × Connector (Battery 6mm) 1 × IC (RTC 1.8V) 1 × Memory (256Kb I2C Serial Board EEPROM) 1 × MS5611 Barometric Sensor 1 × Crystal (32.768kHz TINY) 1 × IC DGTL TEMP SENSOR LP SOT-563 1 × LSM303D 6-Axis Accelerometer 1 × DF13 Top 5Pos 1.25mm 1 × ST L3GD20H 3-Axis Gyroscope
Included Components | ||
Pi HAT Sensor Board | Pi HAT Sensor Board |
---|
Accelerometer | 6-axis internal measurement unit (IMU) |
---|---|
Family | Raspberry Pi |
Barometer | Barometric pressure sensor |
Gyroscope | 3-axis gyroscope |
RTC Battery Holder | Holder for 6mm rechargeable coin cell RTC battery |
Temperature | Ambient temperature sensor |
5-pin GPS Connector | UART connection for Gumstix Pre-GO modules |
Key Components | ||
Connector (Battery 6mm) | Rechargeable coin battery holder |
|
---|---|---|
IC (RTC 1.8V) | IC (RTC 1.8V) |
|
Memory (256Kb I2C Serial Board EEPROM) | CAT24C256 Series 256 kbit (32 K x 8) 1.8-5.5V I2C CMOS Serial EEPROM - TSSOP-8 |
Specs |
MS5611 Barometric Sensor | A high resolution altitude and digital atmospheric pressure sensor accurate to within 10 cm. |
Specs |
IC DGTL TEMP SENSOR LP SOT-563 | Temp Monitoring System (Sensor) |
Specs |
LSM303D 6-Axis Accelerometer | System-in-package featuring a 3D digital linear acceleration sensor and a 3D digital magnetic sensor. |
Specs |
DF13 Top 5Pos 1.25mm | CONN HEADER 5POS 1.25MM STR TIN |
|
ST L3GD20H 3-Axis Gyroscope | IC MEMS MOTION SENSOR 16LLGA. Updated version of ICL415 (L3G4200D) |
Specs |
Mating Connectors |
Please read the instructions in the README file carefully before starting. Instructions and functions are explained in the file.
Files that are needed (such as bootloader and operating system) to create a bootable disk image, are available below.
Our Support page links additional resources.
Software Version: