Featuring the u-blox Neo-7M GNSS module, the PreGO-SMA Board offers a low-cost positioning solution for your location-aware project, delivering ±2.5 meter accuracy. High quality global positioning in a 30x24mm form factor.
Pre-GO modules can connect to any host board with an available UART connection. Logic levels are at 3.3V, and the board is powered by the 5V supply; however, by removing and replacing a jumper resistor, the board can be powered by a 3.3V source.
The GPS antenna is on the board; look at our other board with an SMA connector instead to allow external placement of an antenna.
A Geppetto designer has the choice of including a header on a custom-design that connects via 5-pin cable to one of these PreGO boards as shown by these examples.
Alternatively, the GPS module can be placed directly on a board.
Learn more about this product by checking out the following:
Articles from Gumstix blog
30 mm W
21 mm L
|5-pin GPS Connector||
|DF13 R/A 5Pos 1.25mm SMT||
5 position R/A connector for UART (DF13 series)
|UBlox Neo-7M GPS Receiver Module||
UBlox Neo-7M GPS Receiver Module
Please read the instructions in the README file carefully before starting. Instructions and functions are explained in the file.
Files that are needed (such as bootloader and operating system) to create a bootable disk image, are available below.
Our Support page links additional resources.